1999 Harley Dyna – Died After Car Wash? Cam Sensor Testing & Live Diagnosis

1999 Harley-Davidson Dyna Troubleshooting – LIVE ????️ After a routine power wash, this Dyna rode home fine… then completely shut off and refused to restart. Months later, we’re finally doing the follow-up livestream to diagnose the real cause. In this video we’ll cover: ???? What happened the day it died – Bike cut out immediately AFTER a power wash – No restart, intermittent spark – Original cam position sensor was damaged/previously “repaired” ???? Testing the Cam Sensor (3-wire Hall Effect) – Back-probing reference voltage (5V), ground, and signal – Does it need to be powered? (Yes — Hall sensors require power & rotation to generate a switching signal) – Why you may get NO signal output while cranking – Multimeter vs test light vs LED Noid light – When to replace vs when to troubleshoot wiring ???? New OEM Sensor Install Harley P/N: 32496-99 (Installed live during the stream) ⚠️ Common Symptoms of a Failing Harley Cam Sensor: – Starts then dies – No start when hot – Random misfire – Cutting out after riding – No signal output while cranking – ECU not seeing RPM ???? Affiliate Link – M10x1.00 Tap Used in the Ninja Fork Rebuild (referenced in the video) Amazon link: https://amzn.to/4oP7oO0 ???? Tools Used Today: – Multimeter – Back-probe pins – Dielectric grease – Heat shrink – 3-wire Harley cam sensor – Drain pan, hand tools – Patience