# 1999 Harley Dyna – Died After Car Wash? Cam Sensor Testing & Live Diagnosis

Canonical watch page: https://twitch-nude.com/watch/1999-harley-dyna-died-after-car-wash-cam-sensor-testing-live-diagnosis-v405575

Language: en

Published: 2025-12-01T10:47:13+00:00

Source creator: Quantum Motor Works

Duration: 761 seconds

## Description

1999 Harley-Davidson Dyna Troubleshooting – LIVE ????️
After a routine power wash, this Dyna rode home fine… then completely shut off and refused to restart. Months later, we’re finally doing the follow-up livestream to diagnose the real cause.

In this video we’ll cover:

???? What happened the day it died
– Bike cut out immediately AFTER a power wash
– No restart, intermittent spark
– Original cam position sensor was damaged/previously “repaired”

???? Testing the Cam Sensor (3-wire Hall Effect)
– Back-probing reference voltage (5V), ground, and signal
– Does it need to be powered? (Yes — Hall sensors require power & rotation to generate a switching signal)
– Why you may get NO signal output while cranking
– Multimeter vs test light vs LED Noid light
– When to replace vs when to troubleshoot wiring

???? New OEM Sensor Install
Harley P/N: 32496-99
(Installed live during the stream)

⚠️ Common Symptoms of a Failing Harley Cam Sensor:
– Starts then dies
– No start when hot
– Random misfire
– Cutting out after riding
– No signal output while cranking
– ECU not seeing RPM

???? Affiliate Link – M10x1.00 Tap Used in the Ninja Fork Rebuild (referenced in the video)
Amazon link: https://amzn.to/4oP7oO0

???? Tools Used Today:
– Multimeter
– Back-probe pins
– Dielectric grease
– Heat shrink
– 3-wire Harley cam sensor
– Drain pan, hand tools
– Patience

This page provides video metadata, not a transcript. Watch the video on the canonical page.